can you farm npc with warriors without losses?

[hellomommy]

can you farm a level 5 npc using warriors without any losses?

[Shishir98]

No Using balli and trans is the best way

[Shishir98]

http://evony.gamepedia.com/NPC/Farmi...ch#tab=Level_5


Use this

[Salayer]

I've never seen it done before.

[ssfgrgawer]

NOt using warriors no, however adding warriors to the standard lvl 5 waves will give a bit more exp then the normal farming waves, handy for leveling heros before you can hit lvl 10s.

[Mackay131]

NOt using warriors no, however adding warriors to the standard lvl 5 waves will give a bit more exp then the normal farming waves, handy for leveling heros before you can hit lvl 10s.

Warriors with 1 Archer 1 Pike 1 Sword 1 Cav 1 Phrac 1 Scout will lower your losses.

This can also be used on an All Archer Valley with zero warrior losses.

It is great way to harvest valleys early on with loads of Cav.

See also my previous on harvesting.

Banging an NPC 8 repeatedly under 6 mins is good hero builder using warriors as well.

More bang for your warrior losses.

Giving anything a good wack with warriors such as B10
it is possible to cap a B10 with a low level hero.

Hit B10 with 3 to 5 waves of warriors then a standard B10 wave without transports to lower the pop of the B10 below 360000 warriors, that way 120K plus archers will be successful.

Then keep repeating with lower numbers of archer waves in under 6 mins repeatedly.

The magic number is 40K divided by 3 or just over 13.4K.

Must have warrior and scout shield for archers at all times.

I remember sadly trying to conquer a B5 with ballista when warriors however messy was far more effective.

[LadyBrown]

No, there will always be loses.

[Mackay131]

Good for building heroes but so far as a near loss harvest unfortunately no.

In the early stages, working valleys and flats are more useful for resources.

See my previous on low loss harvesting of valleys.